| |
|
 |
相关文章 |
 |
|
|
|
|
 |
70-059TCP/IP 4.0 试题回顾（2）(1) |
|
|
| 70-059TCP/IP 4.0 试题回顾（2）(1) |
|
作者：佚名 文章来源：不详更新时间：2006-5-30 8:30:42  |
|
person one:
Here s what I can remember:
1. Your company has two WINS servers already installed. You need to install a new WINS server to connect to the internet. How will you configure it?
a. Primary WINS
b. Secondary WINS
c. Caching only
d. Forwarder
(I guessed c. But again I guessed , so be sure to check the answer)
2. Which of the following are valid IP addresses, and which are not? (A drag and drop problem, Cute!)
203.122.153.1 (Valid)
127.96.185.20 (Invalid...Starting octet cannot be 127)
150.206.256.3 (Invalid...An octet cannot exceed from the value 255)
175.207.180.6 (Valid)
3. Your company s subnet mask is 255.255.248.0. Your subnet contains a blend of Windows NT and UNIX machines. You have already assigned them IP addresses from 175.60.8.21 to 175.60.8.49. You want all your Windows NT machines to be assigned IP addresses automatically. Create a scope that consumes all the IP addresses in this subnet. (Another drag and drop situation, where you have to drop the IP addresses in the DHCP scope properties screen)
Include range
From 175.60.8.1 ( 10101111.00111100.00001000.00000001 )
To 175.60.15.254 ( 10101111.00111100.00001111.11111110 )
共4页: 1 [2] [3] [4] 下一页
Exclude range
From 175.60.8.21 To 175.60.8.49
(Make good use of the calculator, or your bust)
4. There were two questions from the transcenders, that a computer .
person two:
I used no books recommended by other members. Just the brain dumps to help me focus on what I ought to know.I used general networking with UNIX TCP/IP knowledge with some NT utilities and that was all.In my thoughts I think TCP/IP is TCP/IP no matter waich Operating system.
Here we go
1)A lot of command line utilities: ARP, NETSTAT, NBTSTAT, NSLOOKUP (know these) as well as PERFOMANCE MONITOR and NETWORK MONITOR. In my test mostly I answered NETSTAT when it appeared.
Question I had include:
a)Which utility will you use to display TCP/IP statisticss in your network(netstat)
b)which utility for IP to physical address(arp)
c)To collect statistics for further analysis(perf mon)
d)to capture packets for analysis(network monito)
2) Know about printing stuff like :What are LPQ, LPD and LPR for?
8) I had 8 scenarios.4 of them had the same requirements and optional required results but each one had different solution.The scenarios had something to do with the the fact that You want
共4页: 上一页 [1] 2 [3] [4] 下一页
to introduce NT server in your network and to enable this server to route:
one said just make it able to route
the other one said enable IP forwarding
the other one one said not only Ip forwarding but also install RIP and so on and so forth.
So I answered invariably as
does not meet
meetsonly required results
meets required and one
meets all
For now this is what I can recall
Well here goes my brain dump-----------
1) there was one question where they give you a exhibit and you are to drag and drop the proper subnet mask for the addresses given and they specify the no. of subnets required
2)they give you a exhibit where wkstn1 cannot connect to server1 ,Both in the same subnet ?
------> subnet mask of wkstn1 makes it lie in a different subnet.
------>change the subnet mask of both the server & wkstn so that they lie on the same subnet (you had to choose two)
3) to capture tcp/ip packets
----->snmp must be installed
4)the buffer of perfmon gets fulll in a min . what to do ?
---->set capture filter (not sure )
5)to check the
共4页: 上一页 [1] [2] 3 [4] 下一页
;netbios cache
------>NBTSTAT.EXE
6)to transfer small data files without any notable overhead in a unix/NT environment
------>TFTP (not sure)
(But ftp was also a choice)
7)you want to connnect to the internet so how do you configure the default gateway of your RAS server as
------>as the ISP routers interface to my internal network (not sure )
8) how will you monitor the print jobs in tcp/ip printing?
----->lpq
9) you want to add a resource record in a DNS server that identifies the mail server
-------> MX
10) You have two DNS server ,how will you setup an additional DNS server for processing queries for internet resource?
---->forwarder
that s all i can recall well 5 killed only 1 more again thanks to everyone and rob for such a wonderful site!!!
共4页: 上一页 [1] [2] [3] 4
|
|
| 文章录入：admin 责任编辑：admin |
| |
|
上一篇文章： Networking Essentials(1)
下一篇文章： 微软认证模拟试题：NTServer4.0(1) |
|
|
| 【字体：小 大】【发表评论】【加入收藏】【告诉好友】【打印此文】【关闭窗口】 |
|
|
|
|
|
